2019 Silverado Key Fob Programming: Step-by-Step Guide

Programming with Recognized Transmitters (Keyless Access Vehicles Only)
If you have a keyless access vehicle and want to program a new key fob, follow these steps:
- Remove the key from a recognized transmitter.
- Place the recognized transmitters in the cupholder or passenger seat.
- Insert the vehicle key into the key lock cylinder on the driver door handle. Then turn the key counterclockwise, to the unlock position, five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE#2, 3, 4, ETC.
- Place the new transmitter in the transmitter pocket/insert.
- Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.
- Remove the transmitter from the transmitter pocket and press unlock or lock on the transmitter. To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.
- Return the key back into the transmitter.
Programming without a Recognized Transmitter (Keyless Access Vehicles Only)
If you do not have a recognized transmitter and want to program a new key fob, follow these steps:
- Remove the vehicle key from the transmitter.
- Insert the vehicle key into the key lock cylinder on the driver door handle; then turn the key counterclockwise, to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.
- Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN, then press the ENGINE START/STOP button. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.
- Repeat Step 3 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1.
- Place the new transmitter in the transmitter pocket/insert.
- Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.
- Remove the transmitter from the transmitter pocket/insert and press unlock or lock on the transmitter. To program additional transmitters, repeat Steps 5–7. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.
- Return the key back into the transmitter.
Professional Programming Required for Separate Key and Remote
If you have a separate key and remote for your 2019 Silverado, it is not on board programmable. This means that you will need to seek the assistance of a qualified professional to program the key fobs for you.
Professional programming ensures that the key fobs are correctly programmed and synchronized with your vehicle's security system. It is important to have this done by a professional to avoid any issues or malfunctions with your key fobs.
When seeking professional programming, make sure to choose a reputable locksmith or automotive service provider who has experience with programming key fobs for the 2019 Silverado. They will have the necessary tools and knowledge to program the key fobs accurately and efficiently.
By following these step-by-step instructions, you can easily program your 2019 Silverado key fob. Whether you have a recognized transmitter or not, you can successfully program a new key fob and ensure that it works seamlessly with your vehicle's security system. If you have a separate key and remote, it is recommended to seek professional programming to ensure proper synchronization. With a properly programmed key fob, you can enjoy the convenience and security of keyless access to your 2019 Silverado.
Leave a Reply